View camera

It is possible to open the layout with the specified camera.

The View camera macro uses the following algorithm:

Searches for the layouts available to the current user that contain the selected camera.
Selects the layout with the minimum number of cells to display the selected camera.
If the required layout does not exist, creates a new layout with the selected camera.
Switches to the selected layout or the created layout.
Performs the specified action.

To configure the View camera macro, do the following:

Select the camera to be displayed (1) or Camera that initiated command execution (see Configuring filters for event-driven macros). You can select a group of cameras for the Switch to archive mode (see step 2).
Attention!
If the macro was triggered by a sensor or a relay (see Configuring filters for event-driven macros) that are not associated with the camera, the action will not be triggered.

Select the display mode (2).

Display mode	Description
Select camera	The camera is highlighted on the layout.
Zoom in camera	The camera is highlighted on the layout, the viewing tile takes up 98% of the screen.
Zoom in and show map	The camera is highlighted on the layout, the viewing tile takes up 50% of the screen, the map under the tile shows the camera.
Switch to immersion mode	Immersive mode is on, the viewing tile takes up 50% of the screen.
Switch to archive mode	The camera is highlighted on the layout and it is in archive mode. If a group of cameras is specified, then a layout is created with all the cameras in archive mode.
Mark camera	The camera is added and highlighted on the Marked cameras layout (see Creating special layouts).
Unmark camera	The camera is deleted from the Marked cameras layout (see Creating special layouts).

The configuration of the View camera macro is complete.

Page tree