Page History

Alarms protocol is a table which contains information about vehicles for which alarm has been triggered (Fig. 4.3—9, 2). It necessary to activate a tab, that is located in the upper area of the On-line monitor window to access to access to the protocol (Fig. 4.3—9, 1).

...

Image Added

Anchor_Ref269387968_Ref269387968Fig. 4.3—9 Viewing the alarms protocol
Unprocessed by operator alarms are underlined red, processed-underlined yellow (see Alarm processing section «Alarm processing»).

...

...

Viewing the alarm protocol is done in a similar way with identified vehicles protocol (see section Viewing the identified vehicles protocol). The difference is that for an alarm there is displayed information about the reason of alarm:

1. «Marked Marked by operator» operator - in case, when the alarm is triggered by operator (the time of triggering is also stated);
2. «Is Is found in: <external database name >» name> - in case, when the identified plate is found in the external database;
3. «Overspeeding» Overspeeding - in case, when the vehicle's overspeeding is registered.

Detailed information about an alarm with stating the reason of alarm one can see in the group Lat event (see section Viewing the data about the last identified vehicle section). Viewing the detailed information about an alarm is similar with viewing the data about the event, registered in the identified vehicles protocol (see section Viewing the identified vehicles protocol section).

In case when the identified vehicle's plate is found in the External Plates Database, the information about the vehicle, stored at this base, will be displayed. (Fig. 4.3—10).
 

Image Added Anchor_Ref269391375_Ref269391375Fig. 4.3—10Information about the vehicle, found in the External Plates database