Viewing the alarms protocol

Alarms protocol is a table which contains information about vehicles for which alarm has been triggered (Fig. 4.3—9, 2). It necessary to activate a tab, that is located in the upper area of the On-line monitor window to access to access to the protocol (Fig. 4.3—9, 1).
Note. There is displayed data about the last alarm on the tab.
Fig. 4.3—9 Viewing the alarms protocol
Unprocessed by operator alarms are underlined red, processed-underlined yellow (see section «Alarm processing»).
Note. Processed events may not be displayed (see section «Hiding the processed events in the protocols»).
Viewing the alarm protocol is done in a similar way with identified vehicles protocol (see section Viewing the identified vehicles protocol). The difference is that for an alarm there is displayed information about the reason of alarm:

1. «Marked by operator» - in case, when the alarm is triggered by operator (the time of triggering is also stated);
2. «Is found in: <external database name >» - in case, when the identified plate is found in the external database;
3. «Overspeeding» - in case, when the vehicle's overspeeding is registered.

Detailed information about an alarm with stating the reason of alarm one can see in the group Lat event (see section Viewing the data about the last identified vehicle). Viewing the detailed information about an alarm is similar with viewing the data about the event, registered in the identified vehicles protocol (see section Viewing the identified vehicles protocol).
In case when the identified vehicle's plate is found in the External Plates Database, the information about the vehicle, stored at this base, will be displayed. (Fig. 4.3—10).
Fig. 4.3—10Information about the vehicle, found in the External Plates database