Page History

To configure

...

the Optex Sensor, do the following:

1. Go to the Optex Sensor object settings panel, which is created on the basis of the Optex

To configure Optex's connection to the Server:

1. Go to the setup panel of the relevant Optex Sensor object.
   

2. In the IP address field, enter the sensor's IP address (1).

   Info
   title Note:
   This IP address can be found in the vendor documentation.

   
   

3. In the Ethernet port field, enter the sensor's communication port (2).

   Info
   title Note:
   By default, 1234 is used.

   
   

4. In the Protocol type drop-down list, select the communication protocol to be used to talk to the sensor (TCP or UDP) (3).

5. Set the Sensor disarmed check box (4) to automatically stop the alarm when the zone exits the Alarm state by hardware. Otherwise, the alarm will be active until the operator processes it.

   Info
   title Note
   The alarm processing method is the same for all areas belonging to one sensor.

   
   

6. Click Apply to save the changes (45).

Optex 's connection tothe Server is Sensor is now configured.