Page History

...

To configure the command, do as follows:

1. Select a camera to be displayed (1).    An An implicit selection of a video camera is also allowed -   Camera that initiated command execution.

   Image Added

   For the Go to archive mode mode (see step 2), you can select a group of cameras.  

   Image Removed

   Info

   title	Note

   In this

   software version, you cannot select a group of cameras for this action

   case, if the launch of the macro command was caused by the triggering of a sensor or relay (see Configuring filters for event-driven macros) that are not associated with any video camera, the action will not be launched.

2. Select the display mode (2).

   Display mode	Description
   Select camera	The camera tile is highlighted on the layout.
   Zoom in camera	The camera tile is highlighted on the layout, the viewing tiles take

   up 

   up 98% of the screen.
   Zoom in and show map	The camera tile is highlighted on the layout, the viewing tiles take

   up 

   up 50% of the screen, the map under the tiles shows the camera.

   Switch

   Go to immersion mode

   Immersive mode, the viewing tiles take

   up 

   up 50% of the screen.

   Switch

   Go to Archive Mode

   The camera window is highlighted on the layout and it is in archive mode.

    

   If a group of cameras is specified, then a layout is created with all the cameras

   in 

   in archive mode.

   
   

3. Specify the number of the monitor on which the camera should be displayed (3).

4. Select the user roles, this command applies to (34).

This command uses the following algorithm:

...