Versions Compared

Old Version 1

changes.mady.by.user Evgeniya Kononova

Saved on

compared with

New Version Current

changes.mady.by.user Darya Andryieuskaya

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  1. The configuration is performed with connected SIP-device through the Ethernet port. Change  Change IP-address of SIP-device on the Wan Setup tab if it’s needed and allow its administrating from outside (Enable WAN web server – yes, disabled on default).

  2. It is recommended to switch the internal “Ethernet” port of SIP-device which is in use to connect video server to the “Bridge” mode on the LAN Setup tab. The device administrating through this port is available only through the “Internet” port. To define the current IP address on the internal device port, connect the telephone to the Line1 port, listen to the voice answer and enter ****, then 210 and # in the tonal mode. To define the external IP address enter **** 110 #.

  3. Set parameters of the SIP protocol on the Line1 tab.

...