Versions Compared

Old Version 1

changes.mady.by.user Alina Luchkina

Saved on

compared with

New Version 2

changes.mady.by.user Gleb Matskevich

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

You On the Detection Tools tab, you can check whether the triggering of detection tools in the Detection Tools tab.To use this option you must perform the following stepsare being triggered. To do this:

  1. In the Detection Tools list of detection tools, highlight the detection tool object whose triggering you need select the one that you want to check.

    Note
    titleAttention!

    The Detection Tool object detection tool should be enabled and configured.

  2. Produce Reproduce an event whose occurrence should trigger upon the occurrence of which the detection tool : motion should be triggered: the start of movement in the frame, turning the video camera, providing sending sound to an audio device, etc.
  3. If the detection tool is configured correctly, video image frames from the video camera corresponding to the detection tool will be displayed on the trigger ribbon with , indicating the time they were received indicated.

...


  1. Image Added
Info
titleNote

If the archive recording is not configured for the camera corresponding to the detection tool (see Configuring recording to an archive), then the trigger ribbon will not contain video frames, because they are taken from archive recordings.

VMS checks the on/off status of detection tools when they triggered and stopped. Not applicable to detection of: quality loss, position change, disappearance of an object, motion stop and ANPR.  

After the end of triggering, you get the the Finished message is displayed.  
Image Removed

Image Added

Checking the triggering of a detection tool is now complete.