Versions Compared

Old Version 10

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version 13

changes.mady.by.user Bahdan Tsiulkou

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

ParameterValueDescription
Other
EnableYesThe detector is enabled by default. To disable the detector, select the No value
No
Name Hands up detectorEnter the detector name or leave the default name
TypeHands up detectorName of the detector type (non-editable field)
Basic settings
Event generation conditionBoth handsSelect this value if you want the detector to generate an event only when a person has both hands raised
One handSelect this value if you want the detector to generate an event only when a person has either left or right hand raised
Only leftSelect this value if you want the detector to generate an event only when a person has one selected hand raised
Only right
Left handSelect this value if you want the detector to generate an event only when a selected hand is raised
Right hand
Number of measurements in a row to trigger detection2

Specify the minimum number of frames with a person with a hand/hands raised for the detector to generate an event. The value must be in the range [1, 20].
The recommended (default) value is 2.
Increasing the value can help eliminate false events , but increases the risk of skips. 
Decreasing the value can help reduce skips, but increases the probability of false events

If necessary, you can configure the detection area. For this, do the following:

  1. Click in the preview window.
  2. Select Detection area.
  3. Set the detection area using the anchor points Image Added in which a person with both hands raised must be detected.
Info
titleNote
Info
titleNote
  • The Hands up detector works in the areas for detection and skip areas specified in the Human pose detector (see Configuring the Human pose detector).
  • For convenience of configuration, you can "freeze" the frame. Click the Image Removed Image Added button. To cancel the action, click this button again.
  • The area for detection is displayed by default. To hide it, click the Image Removed button Image Added button. To cancel the action, click this button again.
  • To delete the detection area, click the Image Added button.

To save the parameters of the detector, click the Apply Image Removed buttonApply Image Added button. To cancel the changes, click the Cancel Image Removed buttonCancel Image Added button.

Configuration of the Hands up detector is complete.