Go to documentation repository
Documentation for Axxon One 2.0. Documentation for other versions of Axxon One is available too.
Previous page Next page
To create the Hands up detector, do the following:
- Create the Human pose detector (see Configuring the Human pose detector).
- Below the Human pose detector, click Create… → Hands up detector.
By default, the Hands up detector generates an event if there is a person with both hands raised in a specified area.
If necessary, you can change the detector parameters. The list of parameters is given in the table:
Parameter | Value | Description |
---|---|---|
Other | ||
Enable | Yes | The detector is enabled by default. To disable the detector, select the No value |
No | ||
Name | Hands up detector | Enter the detector name or leave the default name |
Type | Hands up detector | Name of the detector type (non-editable field) |
Basic settings | ||
Event generation condition | Both hands | Select this value if you want the detector to generate an event only when a person has both hands raised |
One hand | Select this value if you want the detector to generate an event only when a person has either left or right hand raised | |
Only left | Select this value if you want the detector to generate an event only when a person has one selected hand raised | |
Only right | ||
Left hand | Select this value if you want the detector to generate an event only when a selected hand is raised | |
Right hand | ||
Number of measurements in a row to trigger detection | 2 | Specify the minimum number of frames with a person with a hand/hands raised for the detector to generate an event. The value must be in the range [1, 20]. |
If necessary, you can configure the detection area. For this, do the following:
- Click in the preview window.
- Select Detection area.
- Using the anchor points , set the detection area in which a person with both hands raised must be detected.
Note
- For convenience of configuration, you can "freeze" the frame. Click the button. To cancel the action, click this button again.
- The area for detection is displayed by default. To hide it, click the button. To cancel the action, click this button again.
- To delete the detection area, click the button.
To save the parameters of the detector, click the Apply button. To cancel the changes, click the Cancel button.
Configuration of the Hands up detector is complete.