Page History

The Barcode detection module can be configured using the System settings menu, under on the Hardware tab, on the Barcode detection control settings panel, using the Camera settings.

Image Modified

The Barcode detection module is set up configured as follows:

1. Go to the Barcode detection control settings panel.
   Image Modified
2. From the Captioner drop drop-down list, select the captioner with the help of which result will be displayed in the monitor (1)

3. In the Skip repeated recognitions, s field, sec field enter the time in seconds in which the repeated code is recognized (2).

   Info
   title Note.
   If there are some different barcodes or QR-codes one after another, then the recognition is performed instantly. If there are some repeated barcodes then , the new result will be displayed after the time period specified in the settings.

   
   

4. Click the Settings button (3). The Detection settings window will appearopen.
5. Specify the detection surveillance area:
   1. Click the Stop video button to capture the video image (1).
      
   2. Click the Area of interest button (2).
      Image Added

   3. On the captured video image, specify areas to be analyzed. It is possible to add only one area. While When attempting to add the second area, the first one will be deleted. After area specifying, the remaining part of video image will be darkened.

      Info
      title Note.
      To remove the area, click the Image Removed the Image Added button next to the Area of interest button.

      
      

      Note
      title Attention!
      Barcode can be detected not only when the entire barcode or QR code is within the specified area, but also only a fragment of it.

      
      

   4. Click  the OK button (3) to save the changes and return to the control settings panel of the Barcode detection.

      Info
      title Note.
      To return to the control settings panel of the Barcode detection without saving the changes, click the Cancel button.

      
      

6. On the Barcode detection control settings panel, click click the Apply button (4).

Configuring the Barcode detection module is complete.