Page History

The Stopped vehicle detection module can be configured using the System settings menu, under the Hardware tab, on the Stopped vehicle detection control panel, using the Camera settings.

Image Modified

The Stopped vehicle detection module is set up as follows:

1. Go to the Stopped vehicle detection control settings panel.
   Image Modified
2. Click Settings. The Detection settings window will appear.Image Removed

3. Configure

   zones and areas of interest

   the surveillance zones on the Select area tab (1). Several zones can be added

   . Notification is performed on detection tool triggering in any zone. To add a

   (2). Detection tool triggering in each zone produces a separate event.

   Info
   title Note.
   For each surveillance zone, both vehicle stop and vehicle leaving the zone are detected.

   Image Added
   To add a surveillance zone, do the following:

   1. Click Stop Start video (3) to capture the video image.
   2. Click the left mouse button to To add a zone, click any mouse button on the captured video image (1). 
      Image Removed
   3. Set the required size, shape and position of the analyzed areas. To rotate the area, use the board dragging. To drag the area on the frame use the circle dotted line. To change the area size, use the grid points marked squares. The minimal height and size of the smallest base of trapezoid is 0.05 of the frame heightthe surveillance zone:
      • To change the zone size, use the nodal points of the zone;
      • To rotate the zone, drag it, while holding the mouse pointer close to the inner perimeter of the zone;
      • To move the zone around the frame of the video image, use a dotted line circle (4).

   4. Specify the approximate size of the vehicle by changing the size of the internal areas in the bottom left corner of the main areas zone (15). This field (5) is called the detection area.

      Info
      title Note.
      Each surveillance zone over its entire area is proportionally covered by detection areas of a given size. It is necessary to set the approximate dimensions of the vehicle so that each surveillance zone includes no more than 256 detection areas. To control the coverage of the zone by detection areas, use the debug window  The analyzed areas may be covered with not more than 256 detection zones. Recognition of stopped cars is performed only on that part of analyzed area which is covered by these zones. The part of analyzed area will not be covered by detection zones if the car size is much smaller than the size of analyzed area. To control the coverage area by detection zones, use the debug window (see Appendix 1. Debug window). The stopped cars can be detected only in those parts of the surveillance zone, which are covered by detection areas.

      
      

   5. Enter zone name (6Enter none names (2).
   6. Select the direction of the vehicles moving towards the camera for each zone (37).
4. Go to the Parameters tab (1) and set the minimal stop duration in seconds in the Stop duration, s field using the up and down buttons (2).
   Image Removed Image Added
5. Click OK.

Configuring the Stopped vehicle detection module is completed.