Configuring the «Stopped vehicle detection» module

The Stopped vehicle detection module can be configured using the System settings menu, under the Hardware tab, on the Stopped vehicle detection control panel, using the Camera settings.

The Stopped vehicle detection module is set up as follows:

1. Go to the Stopped vehicle detection control panel.
   
2. Click Settings. The Detection settings window will appear.
   
3. Configure zones and areas of interest. Several zones can be added. Notification is performed on detection tool triggering in any zone. To add a zone, do the following:
   1. Click Stop video to capture the video image.
   2. Click the left mouse button to add a zone on the captured video image (1). 
      
   3. Set the required size, shape and position of the analyzed areas. To rotate the area, use the board dragging. To drag the area on the frame use the circle dotted line. To change the area size, use the grid points marked squares. The minimal height and size of the smallest base of trapezoid is 0.05 of the frame height.

   4. Specify the approximate size of the vehicle by changing the size of the internal areas in the bottom left corner of the main areas (1).

      Note.

      The analyzed areas may be covered with not more than 256 detection zones. Recognition of stopped cars is performed only on that part of analyzed area which is covered by these zones. The part of analyzed area will not be covered by detection zones if the car size is much smaller than the size of analyzed area. To control the coverage area by detection zones, use the debug window (see Appendix 1. Debug window).

   5. Enter none names (2).
   6. Select the direction of the vehicles moving towards the camera for each zone (3).
4. Go to the Parameters tab (1) and set the minimal stop duration in seconds in the Stop duration, s field using the up and down buttons (2).
    
5. Click OK.

Configuring the Stopped vehicle detection module is completed.