Versions Compared

Old Version 3

changes.mady.by.user Alena Kniazeva

Saved on

compared with

New Version Current

changes.mady.by.user Alena Kniazeva

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

To create configure the detection tool Noise detector, do the following:

  1. Go to the 

    2. Detection Tools

  2. Detectors tab.

  3. Below the required camera, click Create… → Category: Service → Noise
    4. Detection
  4. detector.

By default, the detection tool detector is enabled and set to detect noise.

If necessary, you can change the detection tool detector parameters. The list of parameters is given in the table:

ParameterValueDescription
Other
EnableYesThe detection tool detector is enabled by default. To disable the detection tooldetector, select the the No value value
No
NameNoise DetectiondetectorEnter the detection tool detector name or leave the default name
TypeNoise DetectiondetectorName of the detection tool detector type (non-editable field)
Basic settings
Alarm end delay10Enter the time in seconds during which the generation of an event won't stop after the noise stops. If noise is detected again within the specified time, it is considered as one event
Percentage of noise in audio stream2Specify the threshold value of noise in the audio stream as a percentage. If the value is exceeded, the detection tool detector generates an event. You must select the value empirically in the range [0, 100]

To save the parameters of the detection tooldetector, click the the Apply Image Modified button. To  To cancel the changes, click the Cancel Image Modified button. 

Configuration of the Noise detector is complete.