Page History

General information

This action allows you to go to a preset of a PTZ camera.

Configuring an action

To configure the action, do the following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. If necessary, select a start condition that triggers
Configure the conditions to start
4. a macro (see Configuring
filters for event-driven macros
5. start conditions).
6. Click the Image Added button.
7. From the drop-down list, select Camera: Go to preset.
8. From the PTZ drop-down list, select
).Select
9. a PTZ device that you want to use
from the PTZ list (1). Any PTZ cameras can be used, including those from other Servers (if they are on).
Image Removed
10. . You can select any PTZ camera, including those bound to another server (if enabled).
    Image Added
    
11. In the Preset number parameter, select a preset
Select the preset (2)
12. to which you want to
switch
13. go when a macro
is initiated.Set
14. triggers
15. In the Speed parameter, set the rotation speed of the camera
(3)
16. . The value must be in the range [1
;
17. , 100].
Set
18. In the
control
19. Control priority
of
20. parameter, specify the camera
(4)
21. control priority. The priority determines
the
22. which user with which access level (see Roles)
will take over the control of the camera when the macro is running. 
23. can control camera during macro execution.
24. In the Time parameter, set the time. If a macro is executed
Set time (5). If the macro is running
25. and the user has a lower access level than the macro, the user
will be able to
26. can control the PTZ camera only after this time has elapsed.
    

    Info
    title Note
    In order to create a sequential switching to specified presets at selected time intervals

...

1. ,

...

1. configure Wait till previous action finishes between the switching actions. You can also set Wait for timeout. In this case, the switching between the presets

...

1. takes place after the timeout time.

2. Click the Apply Image Added button.

Configuration of the Go to preset action is complete.