Page History

Configuring the parameters

...

To configure the Sitting Person Detectioncreate the Sitting person detector, do the following:

1. Create
Pose Detection
2. Human pose detector (see Configuring the
Pose Detection
3. Human pose detector).
4. Below the
Pose Detection, click 
5. Human pose detector, click Create… → Sitting
Person Detection
6. person detector.

By default, the Sitting Person Detection triggers person detector generates an event if a sitting person is detected in the specified area.

If necessary, you can change the detection tool detector parameters. The list of parameters is given in the table:

Parameter	Value	Description
Other
Enable	Yes	The detection tool detector is enabled by default. To disable the detection tooldetector, select the the No value value
	No
Name	Sitting Person Detectionperson detector	Enter the detection tool detector name or leave the default name
Type	Sitting Person Detectionperson detector	Name of the detection tool detector type (non-editable field)
Basic settings
Number of measurements in a row to trigger detection	2	Specify the minimum number of frames with the corresponding pose or behavior for the detection tool to triggerdetector to generate an event. The value must be in the range [1, 20]. The recommended (default) value is 2. Increasing the value can help eliminate false alarmsevents, but increases the risk of skips.  Decreasing the value can help reduce skips, but increases but increases the probability of false alarmsevents

To save the parameters of the detection tooldetector, click the Apply Image Modified button. To cancel the changes, click the Cancel  Cancel Image Modified button.

Configuring the frame perspective 

If a camera angle doesn't meet the requirements (see see Video stream and scene requirements for the Pose Detection Human pose detector and its sub-toolsdetectors), this can result in false alarms.If there are false alarmsevents. In this case, we recommend configuring the frame perspective using the leveling rods. 

For this, do the following:

1. In the preview window, click the Image Modified button.
2. Specify the size of the same person in different parts of the frame by eye
.
3. :
   • To create a leveling rod, left-click the video image to add two anchor points.
You must set
4. • Set at least three

leveling rods. 

5. • calibration rods. The lower anchor points of any three rods must not be located on the same line (horizontal, vertical, slanting, and so on).

   • The size of the leveling rod must be about the average height of a person at this part of the frame.
   • You can resize the rod by stretching its anchor
points 
6. • points Image Modified. You can move it on screen by dragging and dropping.
     Image Modified
     

     Note
     title Attention!
     When you set up leveling rods, the following conditions must be met: the rods that are located at the same distance from the camera lens

,

7. • must be of the same size; the feet of the rods must be located on the same surface (for example, floor); in complex scenes, we recommend adding more than three rods to increase the accuracy of the detection; in the parts of the frame where the lens vertical distortion is observed, the rods must be parallel to the nearest vertical objects (for example, door, wardrobe); for portrait-oriented scenes (such as corridor, shopping aisle, warehouse aisle, and so on), the arrangement of the rods must form triangles.

     
     

     Info
     title Note
     For convenience of configuration, you can "freeze" the frame. Click the Image Modified button. To cancel the action, click this button again. The area for detection is displayed by default. To hide it, click the Image Modified button. To cancel the action, click this button again. To delete a rod, click the Image Modified button.

8. Click the Apply button.

Configuration of the Sitting person detector is complete.