Documentation for Auto Intellect 5.0. Documentation for other versions of Intellect is [available too].

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »

If in the module settings there was selected Only vehicles' length in the classification type (see section «Setting up the Vehicle detector parameters»), the type of detected vehicle (a car, a bus, etc.) will be automatically detected by its length. Data about the detected objects types will be entered in the Vehicle processor database.
There is a possibility to setup the classification of vehicles according to its length.
To setup the classification of vehicles according to its length follow the procedure:

  1. Go to the Vehicle processor settings panel (Fig. 7.7—12).


Fig. 7.7—12 Access to Classification settings

  1. Click the «Clarify settings» button (Fig. 7.7—12).
  2. «ClassificationSetupForm» dialog window will be displayed in result (Fig. 7.7—13).


Fig. 7.7—13 Setting up the classification of vehicles according to its length

  1. In the «Classification name» field (Fig. 7.7—13, 1) enter the name of vehicle classification that is being setup.
  2. To edit the types of vehicles do the following:
    1. In the «Name» column (Fig. 7.7—13, 2) enter the required vehicles types 'names.
    2. In the «From» and «To» columns (Fig. 7.7—13, 3-4) set the length ranges of vehicles, relating to the corresponding types. The values of range boundaries are entered in meters. The type of detected vehicle will be determined on the basis of this vehicle's length fitting one of the ranges.

Note! For every pair of vehicles types the length ranges should not intersect.

  1. To add a new type of the vehicle to the classification click the «Add type» button (Fig. 7.7—13, 5) and in the appeared string perform steps 5.1-5.2.
  2. To delete a vehicle type from the classification select a string, corresponding to the required type and then click the «Delete type» button (Fig. 7.7—13, 6).
  3. Click «Ok» to save the changes ad close the Setting up the classification of vehicles according to its length dialog window (Fig. 7.7—13, 7).

Note. To close the dialog window without saving the changes click Cancel button (Fig. 7.7—13, 8).
Setting up the vehicle classification according to its length is completed.

  • No labels