Setting up the Active monitor component position

Setting up the Vehicle tracer component position is done in the following way:

1. Go to the Vehicle tracer settings panel (Fig. 7.9—2).

Fig. 7.9—2 Setting up the Vehicle tracer component position

1. Go to the «Basic» tab (Fig. 7.9—2, 1).
2. Set the coordinates of the left upper corner of the Vehicle tracer interface component: field «X» (horizontal indent from the left border of the computer's screen) and «Y» (vertical indent from the upper border of the computer's screen) (Fig. 7.9—2, 2). Coordinates are set in percentage in according to screen's size horizontally and vertically respectively.
3. Set the sizes of the Vehicle tracer interface component: fields «W» (component's width) and«H» (component's height) (Fig. 7.9—2, 3). Coordinates are set in percentage in according to screen's size horizontally and vertically respectively.

Note 1. Minimum sizes of the Vehicle tracer window are 70% horizontally («W») and 39% vertically («H»).
Note 2. To set the coordinates and sizes of the Vehicle tracer component in a convenient way it is recommended to use the visual method of setting up the coordinates (Fig. 7.9—3). Click «»button for this (Fig. 7.9—2, 4) and, using the mouse, set the required size and position of the test window and then click «ОК» (Fig. 7.9—3). Coordinates of the test window are automatically calculated and copied to the fields «X», «Y», «W» and «H».
Fig. 7.9—3 Visual method of setting up the coordinates

1. In case, if the Vehicle tracer component has to be moved, set the «Allow moving» checkbox (Fig. 7.9—2, 5).
2. Click «Apply» to save the changes (Fig. 7.9—2, 6).

Setting up the Vehicle tracer component position is completed.