Adding user fingerprints to the system

User fingerprints are added to the system on the settings panel of the BioSmart2 object.
To add fingerprints, do the following:

1. Click the Control fingerprints button.

Fig. 3.8 1 Control fingerprints

1. Find a user by the ID or surname by clicking the Find button (Fig. 3.81, 1).
2. Select the user (Fig. 3.81, 2) and click the Add fingerprint button (Fig. 3.81, 3).
3. Select an available fingerprint reader and click the Select reader button (Fig. 3.82, 1-2).

Fig. 3.8 2 Selecting fingerprint reader

1. Put a finger on the reader and hold it until you hear a beep, then put another finger and repeat actions.
2. Save fingerprints.

The number of fingerprints added for the selected user will be displayed in the box (Fig. 3.83).
Fig. 3.8 3 Number of fingerprints for selected user

1. Add fingerprints for all required users.

Note. To delete fingerprints, select the user in the box and click the Delete fingerprints button (Fig. 3.84).
Fig. 3.8 4 Deleting fingerprints

1. Send configuration to the controller (see Sending configuration to controller section). If the Send VMS data dynamically checkbox is set checked, then there is no need to perform this action.

Fingerprints are now added to the system.