Configure the Impro access point

The access point is configured on the Impro Location object's settings panel. This object is created based on a Impro Zone object on the Hardware tab of the System Settings dialog.

To configure the access point do the following:

1. Go to the Impro Location object’s settings panel.
   
2. From the Number drop-down list select the identification number of the access point (1).
3. From the Enter to drop-down list select the Region object corresponding to the area to which entry is performed (2).
4. From the Exit from: drop-down list select the Region object corresponding to the area from which exit is performed (3).
5. To save changes click the Apply button.

Configuring the Impro access points is completed.