Configuring the Paxton readers

 In the ACFA Intellect system, configuring the Paxton reader on the Reader settings panel is done on the "Paxton NET2" Controller settings panel, on the Hardware tab of the System settings dialog box.

To configure the Paxton reader, follow these steps:

1. Go to the Reader settings panel.
   
2. In the Reader Sub Address field using the up and down buttons, enter the hardware address of the reader connection (1).
3. From the Region in: drop-down list, select the Region corresponding to the reader output side (2).

4. From the Region out: drop-down list, select the Region corresponding to the reader output side (3).

   Note.

   Some settings in the Reader settings panel are not available; changing them will not affect the operation of the system (4). These settings should be made with the Net2Access Control utility (see the reference documentation for this utility).
5. Click the Apply button (5).

Configurations of the Paxton readers are complete.