Configuring the Hikvision alarm input

You can configure a Hikvision alarm input via the settings panel of the Hikvision 26X Alarm Input object, which is created automatically on the basis of Hikvision 26X object after reading the configuration from the corresponding controller (see Network settings of the Hikvision controller and Configuring the Hikvision controller).

To configure the Hikvision alarm input, do the following:

1. Go to the Hikvision 26X Alarm Input object's settings panel.
   
   
2. In the Number drop-down list (1),  you see the alarm input's ID number corresponding to its ID in the Hikvision controller. You can not change this value. 
3. In the Zone Name (2) field, enter the alarm input name under which it will further appear in the Intellect PSIM.

4. Select a detector type from the Detector Type drop-down list (3):

   Emergency Switch	Emergency switch sensor
   Door Magnetic	Door Magnetic
   Smoke	Smoke sensor
   Active Infrared	Active infrared sensor
   Passive Infrared	Passive infrared sensor
   Glass Break	Glass break sensor
   Vibration	Vibration sensor
   Dual Tech.PIR	Dual technology PIR sensor
   Dual technology PIR sensor	Triple technology PIR sensor
   Humidity	Humidity sensor
   Temperature	Temperature sensor
   Combustible Gas	Flammable gas sensor
   Other Detector	Other type of sensor

5. Select a zone type from the Zone Type drop-down list (4):

   Instant	Instant zone
   24 Hours	Permanently controlled zone
   Door Emg. open	Open emergency door zone
   Door Emg. shutdown	Inactive emergency door zone
   Shield Zone	Protected zone

6. From the Sensivity drop-down list (5), select a sensitivity value in milliseconds: 10ms, 250ms, 500ms, 750ms.

The Hikvision alarm input is now configured.