Configure the MicroPoint II control segment

To configure the MicroPoint II control segment go to the settings panel of the MicroPoint II Segment object. This object is created on the basis of the MicroPoint II object on the Hardware tab of the System settings dialog window.

To configure the MicroPoint II control segment, do the following:

1. Go to the MicroPoint II Segment object’s settings panel.
   
2. In the Beginning: field using up-down buttons enter the number of subcell corresponding to the key point in which the control segment started (1).

3. In the End: field using up-down buttons enter the number of subcell corresponding to the key point in which the control segment finished (2).

   Note.

   The range of values of Beginning and End fields is from 0 to 215. It is not recommended to cross control segments.

   Attention!

   Value in the End field should not exceed the value in the Beginning field.
4. Click Apply button.

Configuring the MicroPoint II control segment is completed.