Joint operation of the LPR channel and Radar modules

The Uragan module can operate together with the LPR channel.

When LPR channel and Radar modules operate together, Radar determines the speed of the vehicle whose LP number is recognized by the LPR channel.

To set up the joint operation of the LPR channel and Radar, do the following:

1. Go to the LPR channel object settings panel (2), corresponding to the activated module (see Activating the program module, used for identifying the plates section).
2. Go to the Speed camera settings tab (3).
   
3. In the Speed camera settings drop-down list, select the Speed-trap object representing the speed-trap device directed at the same lane as the LPR channel camera (4).

4. In the Synchronization time field, enter the time period in milliseconds that it takes the vehicle to drive from the spot of speed detection by the Radar speed-trap to the viewing zone of the LPR channel recognition video camera (5).

   Note.

   Synchronization time is needed to synchronize the operation of the Radar and the LPR channel modules.
   

5. Check the Filter events from speed-trap checkbox, if necessary (6). If the checkbox is checked only the first detected speed value is registered, while other values are ignored until the delay expires or until the LP number is recognized.
6. Click Apply (7).

The joint operation of the LPR channel and Radar modules is complete.