Configuring the push notifications in AxxonNet client on Android OS

The push notifications are configured in the Pushes section as follows:

1. In the Notifications period parameter (1) select the autoupdate interval for events:

   • No limit (push notification will be displayed at the moment of event);

   • 5 seconds;

   • 10 seconds;

   • 1 minute.

   Note

   After changing the notifications period, it is necessary to restart the application.

2. Set the Show images checkbox (2) to display the images in push notifications.

   Note

   It is possible to receive push notifications from the Axxon Next Server in case the alarm event on camera is detected.

3. To enable the push notifications receiving, perform the following actions in the direct order: 

   1. Connect to the required Axxon Next Server (see Connection and Server operations in AxxonNet client on Android OS). 

      Important!

      To receive push notifications from the Axxon Next Server, connect this Server to AxxonNet (see AxxonNet Setup and Operation).

      The push notifications from Axxon Next Server can be sent to mobile devices automatically and manually when initiating an alarm event:

      • To send push notifications automatically, it is necessary to configure the corresponding macro to initiate an alarm event on the detector (see Trigger an alarm).
      • Manual alarm event initiation (see Manual Initiation) also initiates sending push notifications to mobile devices.

   2. On the Status tab, go to the Pushes section and click SUBSCRIBE (see The Status tab in AxxonNet client on Android OS).

   3. Make sure the device has access to AxxonNet notifications.
      

      Note

      Push notification is sent only when the alarm on camera is detected. If you don't receive push notifications, restart the Android device.