Documentation for Axxon PSIM 1.0.0-1.0.1.

Previous page Connecting 4/4 and 16/4 Sensor-Relay cards  Connecting SL USBIO cards (4x4, 16x8 and 24x4) Next page


Building security video subsystem with the use of SC200Q4 Low profile (FS115) / SC300Q16 (FX4) / SC300D16 (FX8) / SC310N16 (FX16) / SC230N4 / SC3B0N16 (WS216) /SC590N4 video capture cards one can install 4/4 Sensor-Relay cards (low profile) in order to connect external sensors (DI) and executive devices (DO) to the Server.

4/4 Sensor-Relay (low profile) card appearance is shown in the figure:

Connect the 4/4 Sensor-Relay (low profile) card as follows: 

  1. Make sure that the power of computer is off.

  2. Connect the 4/4 Sensor-Relay (low profile) card to the video capture card with the help of loop bundled with the distribution kit. The loop is connected to J2 and J3 connectors (see the figures below and Appendix 5. Video capture cards pins section).

    Note

    The loop is to be connected to the first row of J2 connectors. One of the outers is marked red in the figures.

    The 4/4 Sensor-Relay card (low profile) can be connected to SC590N4 video capture card both to the first and the second row of J2 connectors.

    The figure showing the 4/4 Sensor-Relay (low profile) card connection to SC200Q4 Low profile (FS115) card:

    The figure showing the 4/4 Sensor-Relay (low profile) card connection to SC330Q16, SC300Q16/SC300D16/SC310N16 (FX4/8/16) cards:

    The figure showing the 4/4 Sensor-Relay (low profile) card connection to SC3B0N16 (WS216) card:


    The figure showing the 4/4 Sensor-Relay (low profile) card connection to SC590N4 card:

    Note.

    SC590N4 card supports up to 8 sensors and 8 relays as two 4/4 Sensor-Relay (low profile) cards can be connected to the J2 connector simultaneously.

    The figure showing the 4/4 Sensor-Relay (low profile) card connection to SC230N4 card:

  3. Connect the cable of computer PSU (disk drive power supply) to J4 connector of the 4/4 Sensor-Relay (low profile) card.
  4. Install the card into vacant computer slot and fix it in the casing with the help of screw.
  5. To connect Sensor-Relay, unsolder the connector. Unsoldering is made in accordance with the external connector pinout of the 4/4 Sensor-Relay (low profile) card.
  6. Connect the ready-for-use connector to external connector of the 4/4 Sensor-Relay (low profile) card in order to connect sensors and relays to the Server.

Attention!

For 4/4 Sensor-Relay (low profile) card proper operation it is essentially required to supply video signal on at least one channel of the video capture card connected to the 4/4 Sensor-Relay (low profile) card.

The 4/4 Sensor-Relay (low profile) card is now connected.