Documentation for Axxon PSIM 1.0.0-1.0.1.

Previous page Configuring sensors and relays connected via IP devices  PTZ configuration Next page


Sensor-Relay cards are integrated via Drivers Pack, so they can be added to the Axxon PSIM hardware tree using the Camera discovery tool.

The AGRG-IO-16/8-WD-DS Sensor-Relay cards are configured as follows:

  1. Launch the Camera discovery tool. To do this, click the Camera discovery tool button on the Settings panel of the Computer object or select the corresponding item in the Computer object function menu in the hardware tree.
  2. In the Ip Wizard window, set the AGRG card checkbox (1).

  3. Make sure that the correct model of the connected device is selected in the Model drop-down list (2).

    Note

    Leave the default values of the settings in all fields.

  4. By default, all sensors and relays available on the device are enabled in the Camera discovery tool. If it is necessary to disable any of them, click on the + button and uncheck the checkboxes next to the corresponding relays (the Executive device object) and sensors (the Contact object).

  5. Click Apply (3).

  6. Click Exit (4).

  7. As a result, the required Video capture device, Sensor and Relay objects will be created in the Axxon PSIM hardware tree. The corresponding type, model and firmware of the AGRG-IO-16/8-WD-DS card will be displayed on the settings panel of the Video capture device object.

    Note

    The IP address field displays the device serial number. If it is necessary to enter this number manually, then to obtain this number, you will need a utility which is available by the link.

  8. If it is necessary to configure the Relay objects − see Creating and configuring the Relay system object.

  9. If it is necessary to configure the Sensor objects − see Creating and configuring the Sensor system object.

Configuring the AGRG-IO-16/8-WD-DS Sensor-Relay cards in Axxon PSIM is completed.

  • No labels