Configuring the Suprema 2 slave controller

One or several controllers can be connected to the Suprema 2 controller. As a result, the Master-Slave mode is created, where the slave controller acts as a reader, and the Master controller makes the decision to grant access (for details, see the official reference documentation for the system by the manufacturer Suprema Inc.).

The Suprema 2 slave controller is configured as follows:

1. Go to the Suprema 2 Slave object settings panel. The object is created based on the Suprema 2 Host object.
   
2. In the ID (1) field, specify the identification number of the controller.
3. From the Region in (2) drop-down list, select the Region corresponding to the area located at side of exit through the controller.

4. From the Region out (3) drop-down list, select the Region corresponding to the area located at side of entrance through the controller.

   Note.

   The Region in and Region out are to be selected if Time&Attendance interface module is in use. Otherwise, leave these fields empty.

5. Click Apply to save changes (4).

Configuring the Suprema 2 slave controller is completed.