Setting up the Parking violation detection module

The Parking violation detection module requires any customized software module for the license plate recognition (see Activating the software module used for identifying the plates section).

To set the Parking violation detection module, do the following:

1. Go to the settings panel of the Parking violation detection object, which is created on the basis of LPR channel object.
   
2. From the PTZ device drop-down list select the ptz device which will perform the passage between presets (1). For details, see Configuring PTZ devices in PSIM™.
3. From the Priority drop-down list select the prz priority (2). If the selected priority is higher than the priority of the telemetry console, then the operator will lose control and the camera will turn to the parked vehicle.
4. In the Time of stop for recording, sec field enter the time interval in seconds during which the vehicle can be in the frame (3). When the vehicle get into the frame, it's license plate is recognizing. If the recognized license plate is in the frame of the same preset more than specified time, the Parking violation alarm is generated.
5. In the Initial preset field enter the number of preset from which monitoring will start (4).
6. In the Final preset field enter the number of preset on which monitoring will finish (5).
7. In the Timeout, sec field enter the time interval in seconds after which passage to the next preset will be performed (6).
8. Click Apply to save the changes (7).

Configuring of the Parking violation detection is completed.