Documentation for Axxon One 2.0. Documentation for other versions of Axxon One is available too.

Previous page AGRG-IO-16/8-WD-DS Sensor-Relay cards  Electrical and technical specifications of AGRG-IO-16/8-WD-DS devices Next page

The AGRG-IO-16/8-WD-DS Sensor-Relay card is an interface of external sensors and external executive devices (relays) as a part of video surveillance and fire and security alarm systems.

The figure shows the appearance of AGRG-IO-16/8-WD-DS card. 

The layout of card connectors:

The device is controlled via the USB interface. Electrical and technical specifications of the card are given in the Electrical and technical specifications of AGRG-IO-16/8-WD-DS devices section.

Connect the AGRG-IO-16/8-WD-DS card to the Server as follows:

  1. Switch the computer power supply off. Remove the system cover.
  2. Install the AGRG-IO-16/8-WD-DS card into a vacant motherboard slot and fix it in the casing.
  3. Connect the loop (bundled with the distribution kit) to the J1 connector and to a vacant USB connector on the motherboard of computer.
  4. To activate the hardware control of the hang, connect the wires to the H2 H3 connector.
  5. To connect sensors and relays unsolder the connector bundled with the distribution kit. 

    1. The connecting wires from the executive devices are soldered to the contacts marked as "Relay" (see the table below).

      ConnectorApplicationConnectorApplication
      1Relay 1 (+)26Sensor 5
      2Relay 127Sensor 5
      3Relay 228Sensor 6
      4Relay 229Sensor 6
      5Relay 330Sensor 7
      6Relay 331Sensor 7
      7Relay 432Sensor 8
      8Relay 433Sensor 8
      9Relay 534Sensor 9
      10Relay 5 35Sensor 9
      11Relay 636Sensor 10
      12Relay 637Sensor 10
      13Relay 738Sensor 11
      14Relay 739Sensor 11
      15Relay 840Sensor 12
      16Relay 841Sensor 12

    2. The connecting wires from the sensors are soldered to the contacts marked as "Sensor" (see the table below).

      ConnectorApplicationConnectorApplication
      17Sensor 142Sensor 13
      18Sensor 143Sensor 13
      19Sensor 244Sensor 14
      20Sensor 245Sensor 14
      21Sensor 346Sensor 15
      22Sensor 347Sensor 15
      23Sensor 448Sensor 16
      24Sensor 449Sensor 16
      25+ 12V (Output)50GND (Ground)
  6. Fix the unsoldered connector in the casing bundled with the distribution kit.
  7. Connect ready-for-use connector to external connector of the card in order to connect sensors and relays to the Server.

The AGRG-IO-16/8-WD-DS card is now connected.

  • No labels