Configuring the Face Detection module combined work with thermal camera or external system

Configure the Face Detection module operation with a thermal camera or an external system as follows:

1. Go to the External source tab (1) on the settings panel of the Face Detection object.
   

2. From the Combined work drop-down list (2) select the combined operation mode:

   • No − combined operation mode is not used;

   • Combine with thermal camera temperature − receiving the temperature and coordinates of a captured face frame from the thermal camera. A photograph of a captured face will be obtained from the capturing camera. If this mode is selected, the following setting become available.

3. Thermal camera reply timeout (3) − sets the timeout in seconds for receiving data from the thermal camera;

   Note

   The FIND_PERSON event will be generated only when the temperature is received from the thermal camera or after the time specified in the Thermal camera reply timeout parameter.

4. • Get photo from thermal camera − receiving the temperature and photos of a captured face from the thermal camera;

   • Get photo and metadata from external system − receiving the temperature and photos of a captured face from a thermal camera or Axxon One.

5. Click Apply (4) to save the changes.