Pre-configuring the RISCO Panel FSA

Before configuring the RISCO Panel FSA in ACFA PSIM, you must do the following on the main panel of the RISCO Panel:

1. Disarm all partitions and zones. You can do this using the user password (default: 1234), by pressing *, entering the password and then pressing #.
2. Enter the programming menu (default password: 1111).
3. Select System → Controls → Communication → CS Enable → Yes.
4. Select Communication → Method → IP → IP Config → Obtain IP → Static.
5. Panel Port → select 1000.
6. Panel IP → specify the required IP address.
7. Mask → specify the required subnet mask.
8. Select Communication → Config. SW → Security → Access code, specify the access code.

Pre-configuration of the RISCO Panel FSA is complete.