Masks detector VL

To configure the Masks detector VL, do the following:

Go to the Detectors tab.
Below the required camera in the settings of the Face detector VL (see Configuring the Face detector VL), enable the Medical mask detection parameter.
Below the Face detector VL, click Create… → Masks detector VL.

By default, the detector is enabled and set to detect faces without masks.

If necessary, you can change the detector parameters. The list of parameters is given in the table:

Parameter

Value

Description

Other

Enable

Yes

The detector is enabled by default. To disable the detector, select the No value

No

Name

Masks detector VL

Enter the detector name or leave the default name

Type

Masks detector VL

Name of the detector type (non-editable field)

Basic settings

Full face masking

Presence

Depending on a particular task, specify the parameters values according to the table:

Event that detector generates	Value
Event that detector generates	Full face masking	Lower face part masking	No mask
No mask of any kind	Absence	Absence	Presence
No medical mask	Presence	Absence	Presence
No balaclava	Absence	Presence	Presence
Any mask present	Presence	Presence	Absence
Medical mask present	Absence	Presence	Absence
Balaclava present	Presence	Absence	Absence

Not selected

Absence

Lower face part masking

Presence

Not selected

Absence

No mask

Presence

Not selected

Absence

Number of consecutive mask detections

2

Specify the minimum number of frames in which the detector must detect a mask in order to generate an event. The value must be in the range [0, 100]

Other types of masks

Presence

Note

The Other types of masks parameter isn't supported in this software version.

Not selected

Absence

To save the parameters of the detector, click the Apply button. To cancel the changes, click the Cancel button.

Configuration of the Masks detector VI is complete.

Page tree