Embedded motion detection

Embedded motion detection detects discrepancies between the current frame and a static background. When motion is detected in the frame, the embedded detector generates an alarm event.

To configure the embedded motion detection:

1. Go to the Detectors tab.

2. Below the required camera, select the embedded motion detection.
3. Set the parameters specified in the table:
   

   Parameter	Value	Description
   Other
   Enable	Yes	By default, the embedded detector is enabled. To disable it, select the No value
   	No
   Name	Embedded motion detection	Enter the detector name or leave the default name
   Enable synchronization events with a video stream	No	The default value is No. All streams are synchronized with the system time individually. If you want all streams to be bound to the timecode of the high-quality stream, set the Yes value
   	Yes
   Type	videoMotionDetector	Detector type (non-editable field)
   Visual Element	Area	Visual element (non-editable field)
   Sensitivity	55	Set the sensitivity of the embedded detector in conditional units. You must select the appropriate value empirically. The higher the value, the lower the sensitivity. The value must be in the range [0, 100]
   Threshold	10	Set the threshold of the embedded detector. You must select the appropriate value empirically. The value must be in the range [0, 100]
   Basic Settings
   Delay time	5	Set the delay time after which the camera begins recording when the embedded motion detector generates an event. The value must be in the range [0, 100]

   
   

4. To save the parameters of the detector, click the Apply button. To cancel the changes, click the Cancel button.

Configuration of the embedded motion detector is complete.