Selecting the Vehicle Processor operation mode

To select the Vehicle Processor operation mode, do the following:

1. Go to the Vehicle Processor object settings panel, which is created on the base of the Computer object on the Hardware tab of the System settings dialog box.
   

2. To enable the mode of imitating the virtual loop, set the Virtual loop (1) checkbox. The result of this mode operation is retranslating the events of vehicles passing in and out from the detection zone, registered by the IntelliVision vehicle detection module. By default, the events are retranslated without storing to the Vehicle processor database. To enable storing the events to the database, perform the step 3.

   Note

   Vehicle speed will be displayed in the Add. info column of the Event viewer interface object if the Virtual loop checkbox is set.

   

3. To enable the mode of collecting and storing vehicles information to the Vehicle Processor database, set the Collect data (2) checkbox .

4. To enable the registration mode and storing the incidents in the traffic to the Vehicle Processor database, set the Register incidents (3) checkbox .

   Note.

   At the moment of writing the documentation, only the Meeting of traffic incidents are registered.

5. Click the Apply (4) button to save the changes.

Selecting the Vehicle Processor operation mode is completed.