Documentation for Axxon One 2.0. Documentation for other versions of Axxon One is available too.

Previous page Next page

If a microphone is a part of an IP server, you must specify the camera to which it is matched in the parameters of this microphone. When you do this, the Microphone object becomes a child of the specified Camera object.

Attention!

When you reassign a microphone from one camera to another, all previously recorded audio archive is also transferred and later played back when you view the archive of the new camera.

This setting is used during synchronized video and audio monitoring of a situation as well as during synchronized video and video recording to the archive (see Audio Monitoring).

In all other cases, the Microphone object is automatically displayed in the object tree as a child object of a camera.

To configure the Microphone object, do the following:

  1. Go to the Devices tab.
  2. Select the Microphone object in the object tree. If necessary, you can change the values of the parameters that are listed in the table:
    ParameterValueDescription
    Other
    EnableYesBy default, the microphone is disabled. To enable it, select Yes
    No
    NameMicrophoneIf necessary, enter the microphone name
    Audio codecRAW

    Select the audio codec used to compress the audio stream. The following audio codecs are supported:

    • AAC, 
    • G.711 araw,
    • G726,
    • PCM
    VolumeHigh levelSelect the volume level of the audio device
    Low level
    Camera
    Camera

    {Short name.Name}

    From the drop-down list, select the camera with which you want to bind the microphone. As a result, the microphone becomes a child of the selected camera (see Camera)
  3. Click the Apply  button.

To check the operation of the microphone, do the following:

  1. Go to the layout with the required camera and activated microphone
  2. In the upper left corner of the preview window, left-click the speaker icon .
  3. Send an audio signal to the microphone.
  4. If the microphone is configured correctly, the audio signal is transmitted to the server speakers. To change the volume level, use the slider. 

Checking the microphone operation is complete.