General information

This action allows you to transmit audio from the client's microphone to the selected speaker.

Attention!

If the client is behind NAT, you must specify the external address of the switch and a port range of at least 1000 ports on the client (see Network settings utility).

Configuring an action

To configure this action, do the following:

  1. Go to the Programming tab.
  2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
  3. Select a start condition that triggers a macro (see Configuring start conditions).
  4. Click the  button below start conditions.
  5. From the drop-down list, select Voice notification from сlient.
  6. In the Speaker parameter, select the corresponding speaker.
  7. In the Microphone parameter, select a microphone.
  8. In the Sensitivity parameter, specify the microphone sensitivity for audio transmission from 0 to 100.
  9. Click the Apply button.

Configuration of the Voice notification from сlient action is complete.

  • No labels