Configuration of the AGRG-IO-16/8-WD-DS sensor-relay cards

Sensor-relay cards are integrated via the Drivers Pack, so you can add them to the Axxon PSIM hardware tree using the Camera discovery tool.

To configure the AGRG-IO-16/8-WD-DS sensor-relay cards, do the following:

1. Click the Ip Wizard button on the settings panel of the Computer object.
   
   As a result, the Camera discovery tool window opens.
2. In the Camera discovery tool window, set the checkbox next to the AGRG card (1).
   

3. Make sure that the correct model of the connected device is selected in the Model drop-down list (2).

   Note

   Leave the default settings in all fields.

4. By default, all sensors and relays available on the device are enabled in the camera discovery tool. If you want to disable any of them, click the + button and clear the checkboxes next to the corresponding relays (the Executive device object) and sensors (the Contact object).
   
   

5. Click the Apply button (3).

6. Click the Exit button (4).

7. As a result, the required Video capture device, Sensor, and Relay objects are created in the Axxon PSIM hardware tree. The corresponding type, model, and firmware of the AGRG-IO-16/8-WD-DS card are displayed on the settings panel of the Video capture device object.

   Note

   The IP address field displays the device serial number. If it is necessary to enter this number manually, then to get this number, you will need a utility that is available at the link.

   

8. If necessary, configure the Relay objects—see Creating and configuring the Relay system object.

9. If necessary, configure the Sensor objects—see Creating and configuring the Sensor system object.

Configuration of the AGRG-IO-16/8-WD-DS sensor-relay cards in Axxon PSIM is complete.