Documentation for ACFA PSIM 1.3.

Previous page Configure the MicroPoint II cable  Configure the MicroPoint II aux input Next page

To configure the MicroPoint II control segment go to the settings panel of the MicroPoint II Segment object. This object is created on the basis of the MicroPoint II object on the Hardware tab of the System settings dialog window.

To configure the MicroPoint II control segment, do the following:

  1. Go to the MicroPoint II Segment object’s settings panel.
  2. In the Beginning field (1) using the up-down buttons enter the number of subcell corresponding to the key point in which the control segment started.

  3. In theEnd field (2) using the up-down buttons enter the number of subcell corresponding to the key point in which the control segment finished.

    Note.

    The range of values of Beginning and End fields is from 0 to 215. It is not recommended for the control segments to overlap one another.

    Attention!

    Value in the End field should not exceed the value in the Beginning field.
  4. In the Alarm fix cause table (3) specify up to 10 alarm descriptions, one of which can be selected by an operator when processing the alarm of a MicroPoint II segment on the map (see Managing MicroTrack II and MicroPoint II control segments).
  5. Click Apply button (4).

Configuring the MicroPoint II control segment is completed.