Documentation for ACFA PSIM 1.3.

Previous page Configuring the connection of AIM SC controller  Configuring the AIM SC reader Next page

The AIM SC controller is configured on the settings panel of the Apollo AIM SC object. This object is created on the basis of the Driver of minor line object.

To configure the AIM SC controller, do the following:

  1. From the Address drop-down list (1), select the address of the AIM SC controller.

  2. Set the appropriate checkboxes (2) and (3) if the bounded readers are used.

    Note

    Bounded readers are used on different sides of the same door. If the readers are single, then they are used on one side of the door, and you can pass from the other side of the door using a button.

  3. In the Type of PIN field (4), select the length of the used PIN code. Select the Do not use value if it's not required to use PIN code.

  4. Set the corresponding checkboxes if it's required to use additional 6 (5) or 32 (6) access levels.

    Attention!

    The maximum number of users that can be stored in controller memory decreases if the additional access levels are used.

  5. Configure the antipassback control. To do this, set the Use zonal APB checkbox (7). To configure global antipassback control regardless of the number of AIM SC controllers, the following is also required:
    1. Create regions in Axxon PSIM.
    2. Assign regions to readers.
    3. Associate each region in Axxon PSIM with a region number in the AIM SC controller (8).

  6. In the Maximum number of cards field (9), enter the maximum number of access cards that will be stored in the controller's memory.

    Note

     The maximum number of access cards that can be stored in the controller's memory depends on the number of memory cards installed on it.

  7. Click the Apply button (10).
  • No labels