Page History
| Section | |||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
General information about working with Vanderbilt SPC integration module
The Vanderbilt SPC integration module is managed through the Map, Equipment Board, and Event Board interface objects, along with Programming rules.
For the information on configuring these interface objects, see Configuring the interactive map, Configuring an Equipment Board and Configuring an Event Board.
For the information on working with these interface objects, see Working with the interactive map, Working with Equipment Board and Working with Event Boards.
For the information on configuring Programming rules, see Programming.
Managing Vanderbilt SPC objects
States
States available for various Vanderbilt SPCobjects are listed in the tables below.
- Server object:
State Icon Link lost 
Launched 
Unknown 
- Panel object:
State Icon State Icon Active alerts 
Engineer mode 
Active alarms 
Link lost 
Inhibited alerts 
Link set 
Isolated alerts 
Unknown 
- Area object:
State Icon State Icon Full set 
Zone inhibited (to one fullset) 
Link lost 
Zone isolated (permanent) 
Not ready to set 
Zone local alarm 
Partset A mode 
Zone masked 
Partset B mode 
Zone post alarm 
Unknown 
Zone soak 
Unset 
Zone tamper 
Zone alarm 
Zone trouble 
Zone frequent 
- Seismic detector, PIR 360, Panic button, Magnetic detector and PIR objects:
State Seismic detector PIR 360 Panic button Magnetic detector PIR Actuated 
Alarm 
Armed 
Inhibit (temporarily) 
Isolate (permanently) 
Link lost 
Masked 
OK 
Post alarm 
Soak 
Tamper 
Trouble 
Unknown 
Commands
Commands accessible via Axxon One interface for various Vanderbilt SPC objects are listed in the table below.
| Object | Commands |
|---|---|
| Main |
|
| Panel |
|
Area |
|
Zone |
|
Overview
Content Tools