Page History
| Section | |||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
General information about working with Satel2 ETHM-A integration module
The Satel2 ETHM-A
...
integration module is managed through
...
the Map, Equipment Board,
...
and Event Board
...
interface objects, along
...
with Programming rules.
For the information on configuring these interface objects,
...
see Configuring the interactive map, Configuring an Equipment Board and Configuring an Event Board.
For the information on working with these interface objects, see Working with the interactive map, Working with Equipment Board and Working with Event Boards.
For the information on configuring Programming rules, see
...
Managing Satel2 ETHM-A objects
Commands accessible via via Axxon One One interface for Satel2 ETHM-A objects are listed in the table below.
| Object | Commands |
|---|---|
| Satel Ethma Input |
|
| Satel Ethma Output |
|
| Satel Ethma One Wire |
|
| Satel Ethma Input Ac |
|
Changing
...
visualization settings of Satel2 ETHM-A objects
In order to change how the Satel2 ETHM-A object is visualized on the map, do the following:
- Configure a map with Satel2 ETHM-A objects added and save the changes.
- Enter the Edit layout / Map mode.
- Left-click the Satel2 ETHM-A object.
- Select a value from Visualization settings drop-down list.
- Save the settings.
Object visualization will be changed according to the set value.