Page History

General information

To configure these actions, select a camera or group of cameras that you want to arm or disarm. You must configure the conditions to start a macro beforehand (see Configuring start conditions).An implicit selection of a camera is also allowed—Camera that initiated command execution.
Image Removed

Configuring actions

To configure these actions, do the following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. Select a start condition that triggers a macro (see Configuring start conditions).
4. Click the Image Added button below start conditions.
5. From the drop-down list, select Camera: Arm or Camera: Disarm.
6. In the Camera parameter, select a camera or group of cameras on which you want to initiate an alarm. In addition, an implicit camera selection is allowed—Camera that initiated command execution (see Configuring start conditions).
   Image Added
   

   Note
   title Attention!
   If a macro is

...

1. initiated by an event from an input or output (

...

1. see Configuring start conditions) that is not connected to any camera, you need to select a specific camera

...

1. for this action. If you select a group of cameras or a camera that initiated the

...

1. macro, the action doesn't start.

2. Click the Apply Image Added button.

Configuration of the Arm or Disarm actions is complete.