General information

To configure these actions, select a camera or group of cameras that you want to arm or disarm.

Configuring actions

To configure these actions, do the following:

1. Go to the Programming tab.
2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
3. Select a start condition that triggers a macro (see Configuring start conditions).
4. Click the  button below start conditions.
5. From the drop-down list, select Camera: Arm or Camera: Disarm.
6. In the Camera parameter, select a camera or group of cameras on which you want to initiate an alarm. In addition, an implicit camera selection is allowed—Camera that initiated command execution (see Configuring start conditions).
   
   

   If a macro is initiated by an event from an input or output (see Configuring start conditions) that is not connected to any camera, you need to select a specific camera for this action. If you select a group of cameras or a camera that initiated the macro, the action doesn't start.

7. Click the Apply button.

Configuration of the Arm or Disarm actions is complete.