Documentation for Axxon One 2.0. Documentation for other versions of Axxon One is available too.

Previous page Control camera  View camera Next page

General information

To configure these actions, select a camera or group of cameras that you want to arm or disarm.

Configuring actions

To configure these actions, do the following:

  1. Go to the Programming tab.
  2. In the Event rules or Cycle rules list, click Create... (see Configuring macros).
  3. Select a start condition that triggers a macro (see Configuring start conditions).
  4. Click the  button below start conditions.
  5. From the drop-down list, select Camera: Arm or Camera: Disarm.
  6. In the Camera parameter, select a camera or group of cameras on which you want to initiate an alarm. In addition, an implicit camera selection is allowed—Camera that initiated command execution (see Configuring start conditions).

    Attention!

    If a macro is initiated by an event from an input or output (see Configuring start conditions) that is not connected to any camera, you need to select a specific camera for this action. If you select a group of cameras or a camera that initiated the macro, the action doesn't start.

  7. Click the Apply button.

Configuration of the Arm or Disarm actions is complete.

  • No labels