Versions Compared

Old Version 4

changes.mady.by.user Gleb Matskevich

Saved on

compared with

New Version Current

changes.mady.by.user Alina Luchkina

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Section


Column
width50%


Panel
borderColor#CCCCCC
bgColor#FFFFFF
titleBGColor#F0F0F0
borderStylesolid
titleOn the page:
Table of Contents



Column


General information about working with Satel2 ETHM-A integration module

The Satel2 ETHM-A integration  integration module is managed through the the Map, Equipment Board, and and Event Board interface  interface objects, along with with Programming rules.

For the information on configuring these interface objects, see see Configuring the interactive map, Configuring an Equipment Board and Configuring an Event Board.

For the information on working with these interface objects, see Working with the interactive map, Working with Equipment Board and Working with Event Boards.

For the information on configuring Programming rules, see Creating and configuring macrosProgramming.
Image Modified

Managing Satel2 ETHM-A objects

Commands accessible via via Axxon One One interface for Satel2 ETHM-A objects are listed in the table below.

ObjectCommands
Satel Ethma Input
  • Clear alarm
  • Disable
  • Enable
Satel Ethma Output
  • Deactivate
  • Activate
Satel Ethma One Wire
  • Clear alarm
  • Disable
  • Enable
Satel Ethma Input Ac
  • Clear alarm
  • Disable
  • Enable

Changing visualization settings of Satel2 ETHM-A objects

In order to change how the Satel2 ETHM-A object is visualized on the map, do the following:

  1. Configure a map with Satel2 ETHM-A objects added and save the changes.
  2. Enter the Edit layout / Map mode.
  3. Left-click the Satel2 ETHM-A object.
  4. Select a value from Visualization settings drop-down list.
    Image Modified
  5. Save the settings.

Object visualization will be changed according to the set value.