Documentation for ACFA PSIM 1.3.

Previous page Access plan settings of the Hikvision reader  Configuring the Hikvision alarm input Next page

Note

The ability to configure multiple Hikvision cards depends on the Hikvision controller/terminal model. Configuration of multiple Hikvision cards will be illustrated by an example of the Hikvision DS-K26x series controller.

You must configure Hikvision card groups beforehand (see Configuring the Hikvision card groups).

To configure multiple Hikvision cards, do the following:

  1. Go to the settings panel of the Hikvision Multicard config object.
  2. Set the Offline authentication checkbox to enable authentication using Super Password when the access point is offline.
  3. From the Number drop-down list, select the configuration number from 1 to 20 corresponding to the configuration number in the Hikvision controller.
  4. From the Timezone drop-down list, select a time zone.
  5. From the Authentication type drop-down list, select the authentication type:
    1. Local Authentication—to access, you need to present only the required identifiers (cards). You can add up to eight card groups to this authentication type.
    2. Local Auth. and Remotely Open—after you present identifiers, an operator will receive a request for remote opening. You can add up to seven card groups to this authentication type.
    3. Local Auth. and Super Password—to access, you need to present identifiers and then enter the Super Password.
  6. To add a card group to the Card group column (2), select a group in the Multicard combination area (1) and click the button.
  7. To remove a group from the Card group column (2), select the required group and click the button.
  8. Use the and  buttons to move a card group within the Card group column (2).

  9. Use the and buttons to change the number of different card swipes required for granting access in the Sw. times column (3).

    Note

    The maximum time between card readings/password entries and other authorization methods must not exceed the time specified in the Multiauthentication swipe time field (see Configuring the Hikvision door).

  10. Click the Apply button. 
  • No labels